Application

Clean Sweep by CLEARTEC corp
Windshield Wiper Clearing Field™ Systems

PROFESSIONAL APPLICATION INSTRUCTIONS
CLEAN SWEEP® WINDSHIELD CLEARING FIELD SYSTEMS™

Regardless of how the wipers operate, Clean Sweep Strips are always applied in the path of the wipers, usually about one inch (25 mm) from the wipers in their lowest or farthest operating position to provide for contraction and expansion of wiper stroke length due to wiper speed selection or windshield wetness.

Although an outdoor air temperature of about 75º F (24º C) with low humidity, in a wind and dust free environment is ideal, applications can be made when glass temperatures are as low as 50º F(10º C). To warm the windshield, turn the vehicle toward the sun, or use a heat gun or hair dryer in addition to turning on the defrost system.

The areas for application must be clean, dry and free of contamination. To remove wax or rain repellant coatings, Clean Sweep recommends using a white powder cleanser such as Bon Ami® and rinsing until water wets out or sheets (instead of beading) then drying thoroughly before applying Clean Sweep Strips.

Clean Sweep Strips should be sized to the wiper before removing the white release liner to expose the pressure sensitive adhesive elements, then applied immediately to the windshield as described above.

With fingertips (or a hard plastic squeegee), rub over the clearing field under the green tape to initiate bonding. This produces a tell tale outline of the entire clearing field for inspection before peeling back (instead of lifting) to remove the green tape and complete the creation of the windshield clearing field.

Although intrinsically durable to last indefinitely, Clean Sweep can be removed without a trace at any time by using a suitable scraper and isopropyl (rubbing) alcohol to wipe away any residual adhesive.

Thirty meter rolls (100 feet) of Continuous Clean Sweep Strips are the lineal equivalent of windshield wiper clearing fields for 30 vehicles, each with two 20 inch (50 cm) wipers. Packaged pairs of Clean Sweep Strips contain two 20 inch (50 cm) strips.

Clean Sweep Strips are made in the USA in accordance with ISO9002 certification.

CLEAN SWEEP ® and CLEARTEC® are registered trademarks of CLEARTEC CORPORATION

Patents issued and pending worldwide.